Sole cleaning machine installation:

1. Select the installation location, adjust the device to a horizontal position, and connect it to the drainage pipe. Plug the power cord with leakage protection into the socket, and make sure the socket is grounded.

2. Connect the water pipes (connect the solenoid valve as the water inlet pipe) and the water pipes (connect the water pump as the water discharge pipe): After placing the equipment, please connect the four-point soft water pipe (factory-provided, in the sink under the strong water-absorbing sponge pad mesh). After the inlet and outlet pipes are connected, place them horizontally at the location where they need to be installed.

3. Handrail installation: If the sole cleaning machine you purchased includes a handrail guardrail, please use scissors or a utility knife to cut the tie straps of the handrail guardrail, place the beautiful cover of the handrail base on the corresponding guardrail holes on the left and right sides of the sole cleaning machine, insert the corresponding feet of the guardrail into the air, and shake the guardrail to install it just right.

4. Power supply: Take out the leakage protection plug (110V-220V), find the three-hole socket (make sure the ground wire is grounded), turn on the switch of the socket, and observe whether the leakage protection socket indicator light is on. If the indicator light is not on, please press the switch button on the leakage protection plug by yourself. After turning it on, the indicator light is on, the equipment is powered on, and the installation is complete.

Notes on placing equipment:

① Make sure the equipment is placed horizontally without shaking or tilting. If it is not level, you can change it by adjusting the movable feet.

②. Make sure the socket is grounded and the voltage is 110V or 220V. If the voltage is too low, the equipment may not operate properly.

③. Make sure that the water inlet and outlet pipes and power cords are straightened out without any bends or pressure.

④. When multiple devices are placed side by side, please ensure that the water pressure of each drainage pipe of each machine reaches at least 0.5Mpa

Horrol Technology's fully automatic cleaning machines are all shipped in wooden boxes, equipped with inlet and outlet hoses that can be connected to the four-point inlet and outlet pipes at the site. When the machine arrives, you only need to connect the inlet and outlet pipes, place the equipment in the right position, and plug in the three-hole leakage protection plug to use it automatically. If equipped with handrails, just plug the handrails into the corresponding empty space of the equipment.