The device does not work or trips:

①. Check whether the power is on and whether the leakage protection plug switch is on.

② Check if the power cord is broken or damaged

③. Check whether the voltage can meet the requirements

④. Check whether the sensor port is properly plugged in

⑤. Check whether the sensor flashes red light. Normally, it flashes for a few seconds and then stops flashing.

⑥. Check whether the control box lights up. Normally, light 6 (manual mode) or light 5 will be on. If the water shortage alarm is turned on, light 3 will also be on. Other lights will not be on.

⑦. Check whether the chain is broken

⑧. Check whether there is any foreign object blocking the chain or drive shaft

⑨. Check whether the belt lock is too tight

⑩. After forced sewage discharge, the sewage discharge button is not reset. Press the forced sewage discharge button again.

The device makes an abnormal sound:

①. Check whether the chain and gears are intact and add lubricating oil from time to time.

② Check whether the bearings at both ends of the driving shaft and the driven shaft are intact.

③. Check whether the trim and LOGO board are properly placed

④ If the water pump makes an abnormal sound, you can disassemble the water pump to check whether there is iron sand and gravel inside

Equipment water inlet and outlet problems:

①. If the equipment does not drain water, the following points can be used to find out the cause of the fault: check whether the sewage pipe is straightened and not compressed, check whether the entire water pump line is intact and all ports are plugged in, check whether the water pump is damaged, and check whether the drainage button is damaged in manual mode.

②. The sewage pump has been working. The cause of the failure can be found through the following points: Check whether the controller has water inflow, check whether the drainage button has water inflow and short circuit

③. If the equipment does not take in water, the following points can be used to find out the cause of the fault: Check whether there is water supply in the water pipe, check whether the water level sensor lights up to indicate water inflow, and check whether the water inlet solenoid valve is working.

There is no need to worry about problems with Horrol Technology's fully automatic sole cleaning machine during daily use. The sole cleaning machine is almost entirely independently developed and produced from the whole to the small parts. As long as you do daily maintenance according to the instructions, there is no need to worry about problems with the equipment that cannot be solved. With professional technical guidance, you can quickly find and solve the problem.